Alinking ALC-9551 Manual do Utilizador descarregar pdf (Página 48)

or cable modem. PPPoE setting must be executed in the LAN environment for your

PC to connect to ADSL. Follow the steps below to complete the setting:

1. Dial: You can select whether or not to dial when you boot the machine.

2. Use DHCP or fixed IP for connection to the LAN environment.

3. Key in the IP address of the camera and enter "PPPoE Setting" following the

route Setting Î Basic Setting Î NetworkÎ PPPoE.

4. Key in the xDSL "Username" and "Password" acquired from your ISP. Click

Save to confirm the setting.

5. Where the ADSL modem and the camera is connected via a switch-hub, you

can press “Reboot” or restart the machine manually to try PPPoE dialing when

the setting of the camera has been completed.

6. A different IP address is obtained after each dial-up network connection. You

can get the new IP address from Setting Î Basic Settings Î System. If you

want to know the new IP address anytime, you must enter Setting Î Basic

Settings Î Notification to set some settings. There are three ways to get

information: 1. SMTP 2. FTP 3. HTTP. For details, refer to the Notification

Setup Menu.

Note: You can use the DDNS function to access the camera. Refer to the

“DDNS Setting” page for more information.

PPPoE setting

 Basic Setting > Network > PPPoE > PPPoE

Dial: You can select whether or not to dial when you boot the machine (On Boot

or Off).

Username: Enter the username provided by your ISP.

Password: Enter the password.

 Basic Setting > Network > PPPoE > PPPoE Information

IP Address: The IP address acquired when dialing has been executed

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 82 83

Sem comentários

Alinking ALC-9551 Manual do Utilizador Página 48